Where in the Enforce management console can a DLP administrator change the 'UI.NO_SCAN.int' setting to disable the 'Inspecting data' pop-up?

Where in the Enforce management console can a DLP administrator change the 'UI.NO_SCAN.int' setting to disable the 'Inspecting data' pop-up?

• A. Advanced Agent Settings from the Agent Configuration
• B. Global System Settings
• C. Policy Management
• D. Detection Rules

Answer: (A)

The setting that controls the “Inspecting data” pop-up is a client-side UI option in the agent configuration. Specifically, you adjust it by going to the Agent Configuration and opening Advanced Agent Settings. This is where administrators tune how the endpoint DLP agent presents UI prompts during scans, including the UI.NO_SCAN.int parameter used to disable the Inspecting data message. Global System Settings affect the overall system behavior, not this per-endpoint UI prompt. Policy Management determines which rules apply, and Detection Rules define what content is detected. So the right place to change how the end-user sees the scan status is Advanced Agent Settings under the Agent Configuration.

The setting that controls the “Inspecting data” pop-up is a client-side UI option in the agent configuration. Specifically, you adjust it by going to the Agent Configuration and opening Advanced Agent Settings. This is where administrators tune how the endpoint DLP agent presents UI prompts during scans, including the UI.NO_SCAN.int parameter used to disable the Inspecting data message.

Global System Settings affect the overall system behavior, not this per-endpoint UI prompt. Policy Management determines which rules apply, and Detection Rules define what content is detected. So the right place to change how the end-user sees the scan status is Advanced Agent Settings under the Agent Configuration.